Your new Royal Spa is in place. Here is how to fill it and bring it up to temperature safely, whether it is your first fill or a refill after a water change.
Step-by-Step: Filling Your Hot Tub
- Fill with a garden hose. Filling through the skimmer basket helps prevent an airlock in the circulation pump.
- Turn the thermostat(s) off at the equipment system in the cabinet and at the command center, if your hot tub has one.
- Turn power on at your disconnect box.
- Make sure the on/off switch is on at the equipment system.
- Make sure the hi-limit switch is pushed in. On 110V units, confirm the GFI breaker is on.
- Confirm the circulation pump is running. Water should flow from the small jets into the footwell. One jet may be the ozonator jet and may not appear to work, which is normal. You can also check the clear tube running from the circulation pump to the heater housing.
- Run the jets for 2 to 3 minutes with the heat still off.
- Check for airlocks at the filter (loosen the bleeder valve on top until water runs out), the circulation pump and the therapy pump.
- Check for leaks at the pump and heater couplers. Hand-tighten if needed.
- Turn the temperature to maximum, check the water periodically, and lower the setting once it reaches your preferred temperature and the heat light turns off. See our hot tub temperature guide.
- Add start-up chemicals as described in the “Refilling Your Spa” section of the Operation and Care Guide. A kit like the Sirona Simply Start-Up Kit covers the basics.
- After 24 to 48 hours, once the water is hot, test alkalinity and pH and adjust. See lowering pH in your hot tub.
- Settle into a routine with our maintenance schedule, and enjoy your spa.
Important: Airlocks can cause instant heater failure, known as “dry firing,” which is not covered under warranty. Always clear airlocks before turning on the heat.
Frequently Asked Questions
How long does it take a hot tub to heat up after filling?
It depends on your fill water temperature and the hot tub. Check periodically and lower the thermostat once you reach your preferred temperature.
Why are some jets not working after I filled the hot tub?
Usually an airlock. Loosen the filter bleeder valve until water runs out and check the pumps. One jet may be the ozonator jet, which can look inactive.
Who do I call with questions about my first fill?
Contact your Royal Spa showroom or the Parts & Service Center at 317-780-2121.


